What’s new in this version?
New features
- For all analog input modules power frequency signals were added.
After enabling the frequency measurement in general, one power frequency signal for each input channel is added.
For each signal the measuring interval can be selected at 1 s or 10 s (according to DIN EN 61000-4-30) - For both central units ibaM-DAQ and ibaM-COM, a status module was added.
Now the status information (input voltage, total current, running time and system state), well-known from the info tab, can be used also as signals. - For the module ibaM-4AI-IEPE bandpass-filtered characteristic values were added in addition to the general characteristic values.
For each channel 6 bandpass filters can be used to calculate RMS, Peak-to-Peak and crest factor, either for velocity or acceleration. - When using the central unit ibaM-COM together with ibaN-2E (firmware v01.02.001 or higher) and ibaPDA, the transmission of the ibaNet-E communication protocol can be set to “High Performance” (HP).
With ibaNet-E HP a data throughput of 750 Mbit/s is possible for each interface of an ibaN-2E board with a synchronization accuracy up to 1 μs between more than one ibaM-COM system.
Further requirements are needed for ibaNet-E HP, mainly a dedicated ibaNet-E network with a maximum of 10 ibaM-COM systems in daisy chain.
Bugfixes
- iba FO devices connected to ibaM-FO-2IO could have sporadic spikes in their signals.
Note: All these new features require ibaPDA v8.12.0 (or higher).
Registered users can download this new version in our download area.
